The Automatic pump control with water-level monitor and digital display is an electrical system constructed for convenient and adequate control of water into overhead tanks (OHT). The device switches “ON” automatically when the water level falls below a certain level and automatically switches “OF” when help tank is filled up. This control function is however through the help of the widely available CD4066, bilateral switches CMOS IC to indicate the water level through the 7 segments display unit. The design ensures a reliable and efficient means of water control, a practical conservation of water and a high speed operation with the help of the electrical motor. It eliminates problems of water overflow by application in both domestic and industrial settings.
List of table Table 5.1: Result Analysis Table 5.2: Bill of Engineering measurement and Evaluation
List of figures Fig 3.1: Schematic diagram Fig 3.2: Battery symbol Fig 3.3: Bilateral switch CMOS IC Fig 3.4: Seven segment display system Fig .5: Forward and reverse bias of diodes with its equivalent Fig 3.6: Switch symbol Fig 3.7: Symbol of Resistor Fig 3.1: Schematic Resistor Fig 4.1: Block Diagram of water level controller Fig 5.1: Representing result analysis in histogram Fig 5.2: Input voltage wave form Fig 5.3: Output voltage wave
Title page Certification page Dedication Acknowledgement Abstract List of tables/figures Table of contents
CHAPTER ONE: INTRODUCTION Thesis Layout
CHAPTER TWO: LITERATURE REVIEW CHAPTER THREE: MATERIALS AND METHODS 3.1 Materials 3.2 Methods CHAPTER FOUR: SYSTEM OPERATION 4.1 The power supply unit 4.2 The control unit 4.3 The sensory unit 4.4 The display unit 4.5 The pump-motor unit CHAPTER FIVE: RESULT ANALYSIS AND DISCUSSIONS 5.1 Water level 5.2 Connection test 5.3 Continuity est 5.4 Signal generation 5.5 Workability test CHAPTER SIX: CONCLUSION AND RECOMMENDATIONS 6.1 Conclusion 6.2 Recommendation 6.3 Problems encountered REFERENCES